Net-optics 4 Station Bypass Switch w_Heartbeat Manuel d'utilisateur télécharger pdf (Page 15)

4 Station Bypass Switch with Heartbeat

The bypass switch will be reset to the following defaults:

Input Timeout Period: 1

Input Retry Count: 3

LFD: On

Bypass Detect: On

Heartbeat Packet: IPX or IP (dependent on selection made in step 2)

Connecting to the Network

To connect a bypass switch segment to the network:

1. Connect Network Port A to the appropriate switch, server or router device.

This acts as your DCE interface.

2. Connect Network Port B to the appropriate switch, server or router device.

This acts as your DTE interface.

Figure 7: Connecting one Bypass Switch segment to the Network

3. Verify that the bypass switch Network Ports are cabled in-line between two

devices.

4. Repeat steps 1-3 for the remaining segements.

Network Monitor

21BA

Network Monitor

21BA

Network Monitor

21BA

Network Monitor

To Switch, Server, or Router

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Net-optics 4 Station Bypass Switch w_Heartbeat Manuel d'utilisateur Page 15