Net-optics 96547iTP Manuel d'utilisateur télécharger pdf (Page 14)

iTap GigaBit Dual Port Aggregator

For security reasons, some parameters can only be set with the CLI.

Use these commands to:

Set CLI username and password

Enable or disable the remote interfaces and display

Turn character echo to the terminal emulation software on or off

You will ﬁ nd a complete list of CLI commands in Appendix B.

If you wish to disable the Management Port and remote interfaces, you can do so

from the CLI using the Display command.

To access the iTap CLI:

1. Make sure power to the iTap is off.

2. Connect a PC with terminal emulation software, such as HyperTerminal, to the

iTap using the RS232 DB-9 cable supplied with the iTap.

3. Launch terminal emulation software and set the communication parameters to:

19200 baud

8 data bits

No parity

1 stop bit

No ﬂ ow control

3. Connect power to the iTap. The CLI banner and login prompt appears.

Figure 6: Login and Password Prompts

4. Type netoptics and press Enter.

5. At the password prompt, type netoptics and press Enter. The NetOptics:

prompt appears.

•

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Pas de commentaire

Net-optics 96547iTP Manuel d'utilisateur Page 14