Net-optics iTap 10 GigaBit Port Aggregator Manuel d'utilisateur télécharger pdf (Page 45)

iTap 10 GigaBit Port Aggregator

4. Enter the IP address of the iTap device in the IP Address text box. Be certain

that the IP address is unique on the network.

5. Enter any relevant information about the iTap device in the Notes text box.

6. Check your settings and click Create. The device appears in the System Manger

system frame.

Figure 21: Net Optics System Manager with a device

The indicator to the right of the iTap device picture blinks green when System

Manager is communicating with the iTap device. If the indicator blinks red for

more than a minute, check that the iTap device is connected to the network and

verify the conguration information.

Repeat this procedure for each iTap device you wish to add.

Tip! _____________________________________________________________________

To change the display order of iTap devices, click and drag them into the desired

order.

__________________________________________________________________________

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Pas de commentaire

Net-optics iTap 10 GigaBit Port Aggregator Manuel d'utilisateur Page 45